Name: SIP Paging Module NTL-X10-SIP
Brand: NuvoTECH
SKU: 9685
Availability: InStock

SIP Paging Module NTL-X10-SIP

sip-paging-module-ntl800-sip

Compare

SIP Paging Module NTL-X10-SIP

SIP Paging Module NTL-X10-SIP

Power	12V 2A input. Power supply is not included. Device can be powered via PoE.
Reset button	Press and hold the reset button for at least 5 seconds then release. The device will play the voice prompt and the system reboots. After factory settings are successfully restored, the system LED will be flashing.
Volume + / –	Press the volume + and – buttons simultaneously for 3 seconds and the device will announce the device’s IP address through the connected speakers.
ETH0+POE	10/100 MPS supports PoE.
ETH1	10/100 MPS.
Dry Contact Signal – Normally-Open Output – Common Input – Normally-Closed Output	There are 3 connectors for Dry Contact Signal.
Digital Level Input + / –	There are 2 connectors for Digital Level Input.
Button1 LED + / – and Switch + / –	There are 4 connectors for Call Button 1.
Button2 LED + /- and Switch + / –	There are 4 connectors for Call Button 2.
Speaker Right + / – and Speaker Left + / –	The are 4 connectors for speaker wiring. The + is for amplified output. This is for connecting directly to speakers. The – is non-amplified. This is used for connecting to an amplified speaker or stereo amplifier.
Audio IN / OUT jacks	3.5mm jacks for audio input and output. The audio out jack can be used for headphones or small speakers.